Kitchens and laundries hold more plumbing per square metre than any other rooms in the house, and a kitchen plumber in Murrumba Downs deals with all of it. Sinks, dishwashers, filter hookups, laundry tubs and washer taps are everyday work for us, along with the valves that shut any one of them off. Every job is done by a licensed plumber, and we work same-day where we can.
If we're late, $100 comes off your bill
From a dripping mixer near the Murrumba Downs Shopping Centre to a full laundry refit in the streets around Castle Hill Village, we cover the lot. Start with our Murrumba Downs plumbing overview for the full picture of what we do, or read on for the kitchen and laundry side.
Kitchen and laundry plumbing is the supply pipes, waste pipes, traps and appliance connections serving the sink, the dishwasher, the washer and the laundry tub. That is the whole system behind the two hardest-working wet rooms in the house.
Under a kitchen sink, the hot and cold supplies each pass through a small valve before reaching the tap. The waste side runs from the basket waste, via the trap, to the waste pipe. The trap matters more than it looks: it keeps a seal of water that stops sewer gas rising into the room.
Everything eventually joins the in-ground private sanitary drain, which links every fixture in the house to the sewer point. Each fixture passes a trap of its own on the way, so kitchen waste and toilet waste can share the one private drain quite legally.
On the laundry side, in general terms, you have the trough, the taps on the wall, and the waste that carries the water away.
An isolation valve closes one fixture's supply without shutting down the entire house, and each appliance here should have its own. Find them now, before you need them: a split hose becomes a quick shut-off rather than a soaked floor.
a small valve on each supply line, so the tap can be serviced with the rest of the house running.
a dedicated valve or wall tap, so the machine can be isolated any time.
a wall tap, closed whenever you swap a hose or one starts to weep.
your water meter's stop tap closes the whole property's supply, turning clockwise. Before closing it, check that nothing, the hot water system included, needs the supply left on.
If a valve will not turn, or you cannot find one for the fixture that is leaking, that is a job for us rather than a pair of pliers.
Notifiable work is plumbing done in a house that's already built: no permit from council and no inspection apply, but the licensed plumber reports it to the QBCC afterwards on a Form 4. Kitchen renovations fall squarely in that category.
The rules in Queensland split the work into three buckets:
fixing or swapping a fixture or fitting. A QBCC licensee does it, and no permit or form applies. A like-for-like tap swap sits here.
putting in a sink, or moving the one there. The plumber lodges the Form 4 with the QBCC inside ten business days of completion, and a copy comes to you. Missing one? The QBCC can provide it.
anything on a combined drain, including adding a fixture where the building shares one. Unit owners do well to ask about permits early, since apartment renovations can need council approval.
The distinction matters most when you are planning the job. Moving the sink to the other wall of a kitchen near Murrumba State Secondary College sits in a different bucket from swapping a like-for-like mixer, and the paperwork follows the bucket.
The QBCC's unregulated list is short: a washer or jumper valve inside a tap, and the cartridge in a household water filter. The rest of the work in these rooms needs a licensed plumber.
The QBCC allows anyone with the appropriate knowledge and level of skill to do those two jobs, though the result still has to meet the standards Queensland requires. A whole new tap, a sink changeover, a dishwasher connection or a laundry tub swap all need a licence. Doing them without one can leave you with a compliance problem when you sell.
If you are unsure which side of the line your job falls on, ring and describe it. We would rather answer a two-minute question than fix a botched attempt.
The big jobs in these rooms each have a page of their own. Here is where the detail lives.
New sink, replacement waste, a trap that keeps leaking or a tap that will not seal: our kitchen sink installation page covers the install and the repair side. A sink draining slowly is usually a waste or trap fault rather than a blockage further down, and we diagnose which before touching anything.
A dishwasher hookup needs a feed, a drain and a mount, all to standard. The dishwasher installation page sets out the visit and what has to comply.
Tubs, wall taps and waste lines in the laundry are general plumbing work, and we handle them alongside the kitchen jobs on the same visit where we can. If a washer hose has split, close the wall tap first, then ring us.
Cartridge swaps sit on the unregulated list, but new filter installations do not. The braided hose under a sink rarely lasts as long as the cabinet around it, and a failed one floods a cupboard fast, so we replace them on request.
$0 call-out fees, available 24/7, and same-day where we can.
Ring (07) 3524 7163 or use the form and describe what's going on in Murrumba Downs. A few details up front mean the right gear comes on the first trip.
We start with the fault you rang about, then check the valves, supplies and waste around it. A drip at the tub and a slow drain at the sink often share a cause. You see what we find before anything is touched.
We give you a fixed quote before any work starts. It's flat-rate pricing with no hidden fees, and we only start once you approve it.
Card and EFTPOS payment on site when the job's finished, or Fix now, pay later if that suits you better.
Expect $0 call-out fees in Murrumba Downs, plus no extra cost for nights, weekends or public holidays.
You'll have a fixed quote before any work starts, with flat-rate pricing and no hidden fees.
Our Fix-It-or-It's-Free guarantee (T&Cs apply) and lifetime labour warranty cover the work, and if we're late, $100 comes off your bill.
We're locally owned and operated and proud MPAQ members, and every job is done by a licensed plumber.
The trough, the wall taps filling the washer, and the waste line carrying the water away. Repairs or changes to any of those are plumbing work, and we handle them all.
Yes, you do. Moving a fixture in a house that's already built is notifiable work, so a licensed plumber does it and lodges a Form 4 with the QBCC inside ten business days of completion. A copy comes to you for your files.
At a joint or a connection, almost always: the trap and waste fittings, where the tap meets the sink, the supply joins, and the appliance hoses. Our kitchen sink and dishwasher pages carry the detail on each.
A pipe serving only your unit, staying within its boundaries and not running through a shared wall, floor or ceiling, is yours to maintain. A pipe supplying more than one unit falls to the body corporate.
The price turns on whether fixtures stay put or move, whether new supply or drain points are needed, how tight the access is, and the fittings you pick. A fixed quote follows once we've seen the job.
Yes, it does. Our work carries a lifetime labour warranty, and the Fix-It-or-It's-Free guarantee (T&Cs apply) covers the job. If something is not right, we come back and make it right.
Book on (07) 3524 7163 for plumbing anywhere in Murrumba Downs. We're available 24/7, there's no extra charge for nights, weekends or public holidays, and every job comes with $0 call-out fees.
Current offers:
T&Cs apply. Mention this offer when booking.
To claim your $0 call-out fee, call (07) 3524 7163 today.